Setting Up The IS8000 (original)

[694]

Again all credit goes to General..

Setting up the ILink IS-8000
1. Connect to TV and Antenna.

2. Connect dongle and network cable to STB.

3. Turn on STB and TV.

4. STB will go to menu.

5. Now copy the latest file to usb stick using computer.

6. Place usb in STB.

7. Go over to the Utility then down to the USB.

8. Now scroll down to the file you want to load today, then hit ok and select the Boot Loader Upgrade. Hit ok. Your file will load and reboot the STB.

9. After it goes back to the menu then Options and Control Panel. Press OK.
Select Local Area. (select the country,state, city) exit.

10. Now scroll to time. Set time and exit.

11. Go to Network and select IP setup. On Network settings select Auto. Then scroll down and select apply. That will populate the rest of the info needed.

Carefully
12. For the IS-8000 do not do anything. Leave it alone. Net Aplication “EPCS”: Do not change anything in here. Go to the next step "13".

For the IR-210
12.For the IR210 Select Net Application then change to EPCS, scroll down to Key and make sure The numbers ************************************* are inserted there and hit ok. (This key is provided by the dealer)
(Was ABDBADADA8ABA8AFAAAAAAAAAAA8ACD8)

13. Check for software update. Scroll to SW download select Upgrade via Network.

14. If new software is available down load and let load and reboot.

15. Go to installations and select Satellite Search.

16. Select Satellites to set up. Now scan from there.

17. Very Simple to set up. Good luck.